Throughout a heavy rain water comes off of the 2nd story roofing system and is disposed onto the initial story roofing system. The issue is where the first tale roof fulfills the 2nd story wall, so this is where we will certainly start. In roof, tiles start at the lower overhang of the roof as well as are laid up the roofing to the peak.
Clean the debris from the location of roof you will certainly be servicing.
Remove the roof cap, starting at the wall surface, back to the length of the initial tile at the top of the roofing.
Get rid of the tiles from the wall. Begin at the optimal as well as work your means to the eve Get rid of only what is needed. In our instance, we removed no greater than one complete shingle (primarily partial roof shingles) completely down.
When the nails as well as tiles are eliminated, load the nail holes with roofing sealant.
At this factor, we might see that the 5x5 flashing, that goes from the roof covering to the wall surface, had actually been installed inaccurately. At this factor we chose the ideal method of repair was going to be to fill in the old 5x5 gap with roof covering sealant and start over with a new design.
Fill up the void, from the bottom of the home siding to the roof covering deck, with roofing sealant. You don't have to be particularly tidy here as it will certainly be covered with new 5x5 flashing as well as 1x4 pressure dealt with trim.
Install new 5x5 flashing per producers referrals. Make certain it is sealed well.
Cut and mount your brand-new shingles. Ensure the edge that lays on the 5x5 steel has a really thick bead of sealer under it.
When your shingles are mounted, mount your leading cap and also you are done with the tiles.
Cut and also set up the 1x4, roughly 2 inches off the roofing system deck, on the wall. Prior to mounting the 1x4 ensure you placed an extremely thick grain of silicone or other sealant behind the 1x4.
Paint the 1x4 as well as flashing.
After the paint has dried, seal the top of the 1x4 to the house siding. Here you will have some nice sized spaces, so see to it you fill them well.
Tidy up your mess and we can go on to the next step.
Earlier we talked regarding lessening the quantity of water that streams onto this roofing system. There was approximately 400 square feet of roofing water being unloaded onto the roofing system listed below. In order to quit this we required to reroute the 2nd tale water right into gutters as well as down spouts leading the water away from this location.
The initial tale roofing in inquiry is back-pitched into a second tale wall surface. Throughout a hefty rain water comes off of the second tale roofing and also is dumped onto the very first story roof. The problem is where the initial story roof fulfills the second tale wall, so this is where we will start. In roof, shingles begin at the lower overhang of the roofing system, https://www.petroff.bg/services-item/remont-na-pokrivi/ and also are laid up the roofing system to the optimal. There was about 400 square feet of roofing system water being unloaded onto the roof covering listed below.